本帖最后由 nonzhe 于 2018-2-24 17:24 编辑
老骥伏枥确实厉害,而且毫不保留,写了这么好的教程。
里面有个com1输出,我附加了一个windows 的pipe监视工具
D:\>vmwaregateway.exe /T
test mode - press Ctrl+C to stop program
pipe connected
vbox配置是这么写的
\\.\pipe\vmwaredebug
上面的配置是com1 主机管道
然后再勇telnet连接 本地的567端口。
Connecting to 127.0.0.1:567...
Connection established.
To escape to local shell, press 'Ctrl+Alt+]'.
First you should test the gateway from a command prompt: vmwaregateway /t
Now connect with you favorite telnet program to localhost 567. The gateway should print out a connect message. Now it is time to setup your VMWare machine. If you have VMWare 2.0 installed that is pretty straight forward - go to Settings/Configuration Editor and set the device type of a serial line to pipe. The name of the pipe is \.\pipemwaredebug. Now start your VMWare box. Directly afterwards the gateway should confirm the connected pipe.
(Using VMWare 1.0 you have to setup the named pipe manually in your configuration's .vmx file. For detailed informat |
|